*The 900 ANSI Lumen LED projector was reduced from 1000 ANSI to 900 ANSI to match theĪpproximate brightness of the 2200 ANSI Lumen lamp-based projector while maintaining the same 2.4x average perceived brightness ratio a 900 ANSI Lumen LED projector (RGBB, ViewSonic X10-4K) Sample image of a 2200 ANSI Lumen lamp-based projector (RGBRGB, ViewSonic PX727-4K) vs. Another ANSI lumen measurement of the adjusted LED projector is then taken, and the ratio of these two measurements is multiplied with the ANSI lumen measurement of the reference lamp-based projector to determine the equivalent “LED lumen” rating.įigure 3. The individual R, G, B currents of the LED projector are then adjusted until the perceived brightness most closely matches that of the reference lamp-based projector. Therefore, ViewSonic has committed to provide both ANSI and LED lumen ratings for our latest LED projectors.ĭetermining the typical LED lumen specification for a given LED projector first requires the selection of a lamp-based reference projector with an RGBRGB colour wheel. To understand why, simply refer back to Figure 1 and understand that the coloured patches on the left only appear to be brighter because the human eye is more receptive to highly saturated coloured light, so an LED projector with colours that are more concentrated in wavelengths will be perceived as being brighter. Magnitude of the HK effect with Red, Green, and Blue monochromatic lightsīy observation, we know that many projectors with LED-based light sources have higher perceptible brightness than many lamp-based projectors, even though they may have the same measured ANSI lumen rating. (Red visual +Green visual + Blue visual) Lumensįigure 2. (Red visual or Green visual or Blue visual) Lumens (Red 100% or Green 100% or Blue 100%) Lumens *the 2.4x average perceived brightness ratio is determined by Viewsonic LED projectors, other LED projectors may have a different result **Perceived Brightness Ratio = Both ratios can be calculated by using the formulas below. The perceived brightness ratio is the difference between the perceived brightness with the measured brightness, while the average perceived brightness ratio is the difference with all the colours combined. The y-axis shows the brightness comparison between the colours on the left and right column on Figure 1. The x-axis of this chart shows each individual RGB colour compositing the light source on the LED projector. attempts to illustrate how the perceived brightness level varies colour by colour. (Simulated image to illustrate the HK effect)įigure 2. In addition, while the coloured patches on the right may appear to have the same brightness as the centre grey scale patches however, the ANSI lumen brightness of the coloured patches on the right is much lower than the centre grey patches.įigure 1. Most observers would assume that the coloured patches on the left are brighter than the grey scale patches in the centre in actuality, they have the same measured ANSI lumen brightness.

To understand how this is possible, we must also understand that the human eye is more sensitive to certain wavelengths of light (Fig 1), and any projector with a light source that more closely matches the light response of the human eye will naturally have a higher perceived brightness.įigure 1 shown below helps to further illustrate the Helmholtz-Kohlrausch effect. Now imagine two projectors with the same measured ANSI lumen brightness that appear to be at different brightness levels. This is mainly due to something called the HK (Helmholtz-Kohlrausch) effect, which causes observers to perceive images with higher colour saturation to be brighter than the less saturated ones. ViewSonic follows industry standard ANSI methods to establish our projector brightness specifications, but ANSI brightness alone can’t always provide enough information to fully characterise the brightness performance of the latest generation of high- colour gamut projectors with LED light sources. Understanding the Difference Between ANSI

Lumen brightness scale